LAUNCH X431 PRO3: Honda Accord Hybrid EBS Sensor Relearn

This article explains how to perform Sensor 0 (Zero) Position Memorization on a 2023 Honda Accord Hybrid using the LAUNCH X431 PRO3 V+ 5.0 Elite.

 

Function Description:

This function allows the ESB (Electric Servo Brake System) on Honda vehicles to relearn the sensor zero position after the assembly, pressure sensor, or related modules have been replaced.

 

Tested Model:

Honda – Accord Hybrid – 2023

Supported equipment:

X431 Pro 10-inch Series Bluetooth scanner
Launch X431 V+ V5.0
Launch Pro3S+ V5.0
Launch X431 PRO3 APEX
Launch X431 Pro3 ACE
LAUNCH X431 PRO3 V+ 5.0 Elite (Same as PRO3S+ Elite)
Launch X431 Pro5 Smartlink

X431 PAD Series
Launch X431 PAD V Elite
Launch X431 PAD VII Elite

 

Execution Conditions:

– Vehicle stopped and ignition switch ON.

– Shift lever in P position.

– 12V battery voltage above 10V.

– No DTCs present in ESB (Electric Servo Brake System).

 

Operating Procedure:

1) Connect the LAUNCH X431 PRO3 V+ 5.0 Elite to the vehicle’s OBD port, then tap [Local Diagnose] – [HONDA] in the X-431 app. It is recommended to use Honda diagnostic software version V49.90 or higher.

 

2) Choose the region to automatically identify the vehicle model. For this test, choose the [USA] region: Click [16PIN DLC]–[USA]

 

3) In the topology diagram interface, select [ESB (Electric Servo Brake System)] and tap[ENTER].

 

4) Choose [Special Function] — [Sensor 0 (Zero) Position Memorization] — . Confirm the conditions, then tap [OK].

 

5) Wait for the pop-up message: “The Operation Has Been Successful“. Then, click [OK]

 

6) Follow the prompts to turn off the ignition switch, and then turn it back on, then tap [OK]

 

Contact:
Email: sales@x431tool.com
WhatsApp: +86 18186426016

 

Be the first to comment

Leave a Reply

Your email address will not be published.


*